Remove the overhead
console lamp assembly then check for continuity between terminals. If the
continuity is not as specified, replace the map lamp switch.
| 1. |
Disconnect the negative (-) battery
terminal. |
| 2. |
Remove the overhead console lamp
assembly.
(Refer to the BD group - "Roof
trim") |
| 3. |
Remove the overhead console bulb (B) after
disconnecting the panoramaroof switch connector and lamp connector
(A).
|
| 4. |
When replacing the bulb only, release the lens
(C) cover from the roof without removing the overhead console lamp
assembly. |
| 1. |
Install the bulbs and connect the
connectors. |
| 2. |
Install the overhead console lamp
assembly. |
